Did you know that the recovery machine market is expected to increase at a CAGR of 5.8% until 2028?
Using an HVAC recovery machine is a safe and efficient way to handle hazardous refrigerant from an air conditioning unit. It is necessary to recycle, recover and recharge refrigerants and other fluids.
Not sure how to use a recovery machine?
Check out our complete guide.
Table of Contents
Read and Follow Safety Instructions
It is important to always read and follow the safety instructions on how to use a recovery machine. You may find a recovery pump that has different instructions depending on its type.
Always wear protective equipment like safety goggles, a face shield, and gloves. Make sure that the machine is grounded and securely attached to the floor and is operating on the correct voltage settings. Following all the safety instructions will help ensure safe, efficient, and productive recovery machine use.
Check the Suitability to the Unit
It is essential to check if the product is suitable for the recovery unit before using it. Look for any markings on the product that might indicate that it is compatible with a recovery machine.
If it has a universal marking, then you can use it with most recovery devices. Ensure that the product is in a proper position and can fit into the recovery unit before attempting to use it. Taking these simple steps on how to use a recovery machine can help avoid any unnecessary damage and ensure its optimal performance.
Connect the Recovery Machine
To know how to use a recovery machine, locate first the connection of the recovery machine HVAC’s system. From the unit, get the appropriate hoses to attach to the inlet and outlet.
Once these hoses are connected, attach the appropriate straps to ensure a good, secure connection. Connect the power cord to a power source, and the recovery machine should be ready to run.
Turn On and Select ‘Recovery’ Mode
To begin recovery, start by switching the machine on, then select the “recovery” mode. This is the most important step in how to use a recovery machine. When you press the yellow recovery button, the device will start taking refrigerant from the a/c recovery machine.
The LCD on the air conditioner vacuum pump will show the levels of recovered refrigerant and when the levels reach 100%, the process is complete. After the recovery process, air filters or strainers within the system must be replaced. With adequate maintenance performed, HVAC systems can operate efficiently.
Disconnect and Turn Them Off
After completing the HVAC recovery process, detach all connections and turn off the machine. Give the unit a few minutes to cool down before you disconnect the lines.
Once the power sources are off, it is safe to open the HVAC vacuum pumps for maintenance. Tighten all the valves to prevent leaks and make sure to store the recovered refrigerant properly. This is the last step on how to use a recovery machine and make them ready for future jobs.
Consider This Guide on How to Use a Recovery Machine
Knowing how to use a recovery machine is the key to a successful job when performing HVAC maintenance. You need to read and follow instructions first, check the suitability of the unit, connect the recovery machine, turn it on and select recovery mode and detach all connections and turn it off after the recovery process.
Do you find this article helpful? Then, be sure to check out our other blog posts.
